Most hidden leaks start small. A joint inside a wall weeps a few drops an hour, the water soaks into plaster or runs along the slab, and nothing shows for weeks. By the time a stain appears, the leak has often been running for months. The good news is that a few simple checks can reveal a leak long before it becomes expensive.
1. Watch your water use
A water bill that rises without any change in how you use water is the most reliable early warning. If your supply has a meter, close every tap and appliance, note the reading, and check again after an hour without using any water. If the reading has moved, water is going somewhere it should not.
2. Listen to your pump
If your building uses a pressure or booster pump, it should stay quiet when no one is using water. A pump that switches on by itself every few minutes is topping up pressure that is being lost through a leak.
3. Look low and look high
- Bubbling or flaking paint near skirting boards and wall bases.
- Stains or a soft feel on ceilings below bathrooms and kitchens.
- Tiles that sound hollow or have dark grout lines that never dry.
- Swollen kitchen or vanity cabinet bases.
4. Trust your nose
A musty smell in one room, especially one that gets stronger after the water has been in use, is often the first sign of moisture behind a finish. Mould spots in corners or behind furniture point the same way.
5. Check the obvious joints
Open the cabinets under sinks and basins and run your hand around the trap, the flexible connectors and the isolation valves. Look behind the toilet at the cistern supply. These visible joints account for a large share of slow leaks and are quick to fix.
Why the damp spot is not the leak
Water follows pipes, slab joints and gravity, so a stain can appear a metre or more from the real fault. Sealing or painting over the spot hides the symptom and lets the damage continue. Proper leak detection uses pressure testing and moisture readings to trace the water back to the failed joint before anything is opened up.
What to do if you find signs
- Note when you first noticed the signs and take photos.
- If water is visibly escaping, close the nearest isolation valve or the main stopcock.
- Avoid using electrical sockets near wet areas.
- Ask a plumber to test and locate the leak rather than patching the surface.
Need a hand? Book a PluPlex visit or read about our pipe leak repair and pipe fitting services.