New supply lines, extensions and complete re-piping in the right material, sized, supported and tested properly.
Good pipe fitting is mostly invisible. It is the correct pipe diameter for the flow you need, the right material for hot or cold water, joints made exactly to the manufacturer’s method, and clips at the right spacing so nothing sags or strains over time.
We install new pipework for renovations, extensions and fixture changes, and we replace old corroded GI lines with modern PPR or CPVC systems. Every installation is planned with you first, routed neatly, and pressure-tested before walls are closed.
Narrowed, corroded pipes restrict flow to upper floors and far taps.
Common in ageing GI lines that are corroding from the inside.
Several repairs in a short time usually mean the system is at end of life.
The best time to re-pipe is while walls and floors are already open.
We check the existing system, pressure and fixtures, then agree a route, materials and price.
The supply is isolated, the area protected and old pipe removed where it is being replaced.
Pipe is cut, joined and clipped to specification with valves where you will need them.
We pressure-test the new system, flush it, check every outlet and show you the isolation points.
For most indoor supply lines we fit PPR with heat-fused joints. It handles hot and cold water, does not corrode and has very few failure points.
Usually yes. We work room by room and keep water available in the evenings wherever possible.
Yes. We install and connect pumps, overhead and underground tank lines, and float valves.
A typical flat takes three to five working days depending on access and the number of fixtures.
Call or message us and a plumber will advise you while help is on the way.
We reply with an arrival window and a cost range.
Book a survey and we will plan the route, material and cost before any work begins.