A look at the kinds of pipe jobs we take on every week, from a single hidden leak to complete system replacements.
Each example below reflects a common type of job: what was wrong, how we approached it and what the owner was left with.
The problem: A pressure pump switching on every few minutes with every tap closed.
What we did: Isolated each branch to find a weeping union inside a wall cavity, opened one tile, remade the joint.
The result: Pump cycling stopped and the next water bill dropped back to normal.
The problem: Rusty water and weak pressure on the upper floor of a two-storey house.
What we did: Replaced the corroded GI risers and branches with PPR, added isolation valves on each floor.
The result: Clean water and even pressure at every outlet, with no more patch repairs.
The problem: Exposed pipes cracking where they crossed a sun-facing wall.
What we did: Rerouted the lines, switched to UV-suitable pipe and fitted proper clips and sleeves.
The result: A tidy, supported run that no longer flexes or splits in heat.
The problem: A new kitchen needed hot, cold and waste lines before plastering.
What we did: Planned the route with the contractor, fitted and pressure-tested all lines in one visit.
The result: Walls closed on schedule with tested pipework and a photo record behind them.
The problem: Several dripping joints on a building water supply manifold.
What we did: Scheduled an out-of-hours shutdown, remade the failed joints and replaced two worn valves.
The result: The building was back on supply before opening time with no leaks.
The problem: Water loss showing at the meter with no visible damp anywhere.
What we did: Pressure-tested the buried supply line, found a split near the meter and replaced the section.
The result: Meter readings returned to normal usage the same day.
Every job starts with testing.
Price and scope approved by you.
Rated fittings, correct joints.
Pressure test before handover.
Send us a short description or a photo and we will suggest the right approach and a cost range.