PluPlex

PPR, uPVC, CPVC or GI: Choosing the Right Pipe

Many repeat leaks we see are not caused by poor luck but by the wrong pipe in the wrong place. A cold-water pipe carrying hot water, or a corroding steel line left in service decades past its life, will keep failing no matter how often it is patched. Here is how the common materials compare.

PPR (polypropylene random copolymer)

PPR is our default for indoor hot and cold water supply. Its joints are made by heat fusion, which melts pipe and fitting into a single piece with no glue or thread to fail. It does not rust, keeps water clean and handles typical domestic temperatures and pressures comfortably.

  • Best for: hot and cold supply lines inside the building.
  • Watch for: needs proper support and should not be left exposed to strong sunlight.

uPVC (unplasticised PVC)

uPVC is light, affordable and easy to join with solvent cement. It is excellent for cold water and for drainage and waste lines, but it should never carry hot water.

  • Best for: cold supply, drainage, waste and vent pipes.
  • Watch for: becomes brittle under heat and UV exposure without protection.

CPVC (chlorinated PVC)

CPVC looks similar to uPVC but is made to handle higher temperatures. It is a good choice where a solvent-welded system is preferred for hot water lines.

  • Best for: hot water lines and water heater connections.
  • Watch for: must be joined with the correct CPVC cement, not standard PVC cement.

GI (galvanised iron)

GI was the standard for decades and is still found in many older buildings. It is strong, but its zinc coating wears away and the steel corrodes from the inside, causing rusty water, reduced flow and leaks at threaded joints.

  • Best for: some external, exposed or riser applications where strength matters.
  • Watch for: if your GI lines are giving rusty water or repeated leaks, replacement is usually more economical than repair.

Copper

Copper is durable and looks good on exposed runs, but it costs more and needs skilled soldering or compression fittings. It is used where appearance or specific fittings call for it.

Our rule of thumb

Choose by what the pipe carries, how hot it gets, the pressure in the system and whether it will be exposed. Mixing materials is fine when the right transition fittings are used, but never use a material outside its rating to save time or money.

Need a hand? Book a PluPlex visit or read about our pipe leak repair and pipe fitting services.

Scroll to Top